Developer Hardware Units Reference

During our early access program, we sent thousands upon thousands of early revision units to developers around the globe for free. The Revision 4 series was sent out in October and November 2012, while Revisions 5 and 6 were launched in December 2012 and January 2013. The final production version that launched in July 2013 was Revision 7.


At the time of writing, Revision 6 models should still continue to work fairly well, though ongoing support is not guaranteed as our software continues to evolve. Here’s a quick reference for all the amazing early revision developers who helped us get to where we are today.


In terms of size, Rev 4 was the largest module we’ve ever made. Its dimensions were 92 mm x 30 mm x 20 mm. The reason for this was a purposefully conservative circuit layout design, which allowed us to quickly iterate and debug the hardware. Its range and accuracy were significantly less than the next generation.


The Rev 5 module used the final PCB size of 72 mm x 23 mm, though its height was still larger than Rev 6, because we used pre-production (off-the-shelf) lenses as seen in Rev 4. The unit was produced inside of an aluminum box which resembled the final product (aside from the much larger height).


The Rev 6 module featured a custom optical assembly, which reduced the height to less than half the Rev 5 device. Since our final LEDs have a special emitter/optical combo, Rev 7 expanded the LED/sensor field-of-view from 110 degrees to a much larger 140 degrees.


Want to learn more about the evolution of the Leap Motion Controller? Read industrial designer Kyle Hay’s blog post on designing the hardware.

Have more questions? Submit a request

0 Comments

Article is closed for comments.